Filter
Top Products
Install the Camera Cover.
1
Put the camera cover over the main unit
and hook the 2 tabs of the camera cover
to each hole in the plate.
2
Fasten the camera cover by turning it to
the right.
3
Attach the 2 caps to lock the cover to the
mounting bracket of the camera.
Hole
Tab
Confirm that the 2 tabs are fit to
each hole in the plate by watching
through the openings.
Note
After the installation, dust, dirt or insects may
get into the camera cover. Remove them by
regularly removing the camera cover.
Groove
■ Wiring Without Making Holes in the Ceiling
Remove the notch from the camera cover and pass the wires
through the hole.
■ Removing the Camera Cover
Insert a flat head screw driver into the groove and remove
the caps, this will unlock the camera cover from the mounting
bracket of the camera.
About 169 mm (6 5/8 inches) × 154 mm (6 1/16 inches)
× 169 mm (6 5/8 inches)
Specifications
Dimension (WHD)
Weight
About 180 (0.4 lb.)