Filter
Top Products
OPERATING INSTRUCTIONS
6/18/07
Replacement Parts List and Accessories
Replacement part numbers
SKORPION ™ Model
Heating
Element
Temp
Control
Power
Control
Blower
Nozzle
Tube
F075615 1.5kW 120V 1PH 12.5A F205526 F205499 F205486 F205513 F205494
F075616 3.0kW 240V 1PH 12.5A F205502 F205499 F205486 F205512 F205494
Optional Attachments
(all models)
F075744 High Flow Nozzle
21mm (1”) diameter
F075745 Standard Flare
150mm x 12mm (6”x0.5”)
F075746 Wide Flare
300mm x 4mm (12”x 0.16”)
Replacement Procedures
I.
Replacing the Heating Element
1. Turn heater/blower switches OFF, and disconnect from power source.
2. Use a flat screwdriver to remove (pry open) the wiring cover under the stainless nozzle
tube.
3. Remove the stainless nozzle by removing the two mounting screws, and the thru-bolt
which passes through the plastic support tower and threads into the nozzle flange.
4. Disconnect the KTC+ (Yellow), KTC- (Red), HTR1, HTR2 connections from the wiring
terminal as shown. Total of four wires.
5. Remove the old element, pulling the KTC and HTR wires through the plastic support
tower.
6. Install new element by reversing steps 2-5.
II. Replacing the Temperature Controller
1. Turn heater/blower switches OFF, and disconnect from power source.
2. Remove the four screws which secure the black plastic top cover plate.
3. Lift the white plastic mounting tab and gently push the temperature controller halfway out
of the faceplate.
OSRAM SYLVANIA
131 Portsmouth Avenue
Exeter, NH 03833 USA
Tel: 603-772-4331
Fax: 603-772-1072
5