Filter
Top Products
ENGLISH
4
Operating Instructions
To Operate
Make sure disposable paper filter dust bag is in place. DO
NOT operate the cleaner without a paper filter dust bag.
Plug the power cord into an electrical outlet and press the
On(l) - OFF(O) switch on handle assembly when ready to
operate.
General Information
The performance of your new cleaner greatly depends upon
care and maintenance. The instructions in this manual will
guide you in performing basic care and maintenance. To
obtain the most satisfying years of service read the instructions
and keep them handy for future reference.
Operating Recommendations
This new ORECK XL High-Speed Upright is one of the finest,
fastest, and strongest units in its class. You’ll love the way it
cleans, gets under things, and it’s SO lightweight and easy to
use.
The following are a few simple suggestions regarding its
operation:
1. When inserting a new disposable paper filter dust bag—
FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or
makes an unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do
so may result in permanent damage to the motor suction
fan and its housing.
5.
WARNING: Do not use your vacuum cleaner on damp
or wet surfaces. This will cause damage to the vacuum
cleaner and is dangerous to the user. Damage caused by
use on wet or damp surfaces is not covered under
warranty.
6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a
month—even if it is not full! The collected dust in the dust
bag can cause odor
, attract moisture, act as a breeding
ar
ea and can af
fect the efficiency of the cleaner.
8.
DO NOT run the vacuum cleaner over cord. The
r
e
v
ol
ving brush could damage the cord.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role
in the efficiency of your ORECK vacuum cleaner. The purpose
of the paper bag is to trap dirt, but at the same time it must
be porous enough to allow air to pass through. If the paper
bag becomes clogged, no air can pass thr
ough the cleaner
and cleaning cannot take place, regardless of the cleaner’s
power
. Increase the CLEANING POWER of your cleaner by
changing the bag often.
T
o keep your cleaner operating at maximum ef
ficiency
,
change the dust bag frequently. DO NOT FILL ABOVE THE
LINE INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed
properly.
Assembly
5
4
6
15
14
7
8
13
12
9
1
2
3
10
11
To assist you in identifying
components of your vacuum,
the parts have been numbered
as follows
:
1
Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
With ON/OFF switch facing
the fr
ont of the unit, slide
upper handle section over
matching section of the
connector assembly. Insert
short screw into top hole and
long screw into the bottom
hole then tighten firmly until
handle is no longer loose.
1
2
3
Upper
Handle
Connector
Assembly
Before assembling appliance,
remove two screws from the
connector assembly. Remove
cardboard insert by pulling
upward.
Attach cord to cord clip by
pr
essing cor
d above and
below clip ensuring the cord
is fully rested in clip.