Filter
Top Products
4
This guarantee is given in addition to the rights you have
against the manufacturer or supplier from whom you purchased
this product. This product is guaranteed for three (3) years
against faulty material or workmanship. The casing is
guaranteed for ten (10) years. This limited warranty covers the
revolving roller brush for one (1) year for residentail use only. If
a part is found to be defective from the date of purchase
agreement, we will replace or, at our option, repair that part
without any charges for material or labor; ONLY if the appliance
has been used for those purposes in accordance with the
instructions provided with each appliance and has not been
connected to an unsuitable electricity supply or subjected to
misuse, neglect, damage, stuffing or blockage, or modified or
repaired by service stations not authorized by ORECK or a
representative of ORECK.
Please note that proof of purchase is required.
When writing or telephoning, please give the following information:
A. Your name, address and telephone number.
B. Model number and name of product.
C. Date of purchase.
D. Fault if known.
You will be advised what action to take by our customer service
staff. This guarantee will be invalidated if spares other than the
manufacturer’s are used.
GODFREYS.
2103 Dandenong Road
CLAYTON, VICTORIA 3168
FREE CALL
03-9540-0700
Guarantee
Guarantee
ORECK XL
No. 1 for Easy, Powerful Cleaning since 1963
Hypo - Allergenic Cleaner Plus
Compact Barrel Cleaner
T
roubleshooting Guide
W
ARNING: Unplug cord from electrical
outlet before servicing.
SAVE SERVICE CALLS...CHECK THESE FIRST:
• Is the disposable filter dust bag full?
•
Are pores of filter dust bag clogged with powder or fine dust?
• Is anything clogging the revolving brush, lower tube, intake opening,
fan housing or connector assembly opening?
• Is the belt in place and turning the brush?
• Are the brush ends in the proper location?
• Does the brush turn freely? Are hair, string or rug fibers wound around
the brush?
CLEANER
W
ILL NOT RUN
CLEANER
DOES NOT PICK UP
Not plugged in
properly.
No electricity in wall
outlet.
Filter bag is full.
Nozzle or intake
pivot clogged.
Belt is broken or
stretched.
Brush is worn.
Lower tube clogged.
Bag pores are
clogged with fine
dust.
Impeller fan is
broken.
Revolving brush is
not even at both
ends.
Be sure cleaner is
firmly plugged into
wall outlet.
Check electrical
source–fuse or
circuit breaker.
Replace filter bag.
See “To Replace
Paper Filter Dust Bag.”
Clear obstruction.
Replace belt.
See “To Adjust or
Replace Brush.”
Clear obstruction.
Change bag.
Return to Service
Center for repair
.
Check brush roll end
cards. Make sure
words “OLD” or
“NEW” match at
each end.
PROBLEM POSSIBLE SOURCE AREAS TO CHECK
Whenever calling, please be sure to have your model and serial
number from data plate.
CALL CUSTOMER SERVICE HOT LINE
03-9540-0700
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.