Filter
Top Products
7
ENGLISH
SPECIAL
N
ORMAL
The light assembly should be replaced by an Oreck authorized service center whenever it fails to light during operation.
Replacing the LED Light
WARNING: Unplug cord from electrical outlet before servicing.
Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.
Remove both edge brushes and replace with new ones. Replace both screws and tighten.
Replacing Edge Brush
Your ORECK XL21 vacuum cleaner has a special ORECK FRESH AIR
®
tab pocket.
This light-colored pocket is located inside the outer cloth bag in the area where the
paper filter dust bag attaches to the intake tube. Insert tablet in pocket if desired.
Using an Oreck Fresh Air
®
Tab
WARNING: Unplug cord from electrical outlet before servicing.
The Motor Filter located at the back of the power head should be replaced every 2 months.
The Scent Disk should be replaced every month when changing the inner filter bag.
Press two locking tabs on scent cartridge cover and remove the cover.
Remove the cartridge holder by lifting on tab at top of holder.
Remove old filter or scent disk from holder. Replace filter or scent disk and reinsert holder.
Replace door by aligning tabs on door with slots in housing and pressing the door in place until tabs lock.
Replacing Motor Filter and Oreck Fresh Air
®
Scent Cartridge
1
8
19
2
0
21
22
23
24
23
22 23
24