Filter
Top Products
BAG REMOVAL:
1. Unsnap bag door from base.
2. Gently pull bag from
cardboard collar upwards.
3. Dust seal will close
automatically
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock
door.
2.
Fir
mly push bag dock door
with both thumbs on
indication point until
it snaps.
2
4
Assembly
To Replace Filter
Dust Bag
WARNING: Unplug cord from
electrical outlet before servicing.
ENFONCEZ JUSQUENFONCEZ JUSQU’À’À
ENTENDRE UN BRUITENTENDRE UN BRUIT
PRESIONE HASTPRESIONE HASTAA
ESCUCHAR UN ESCUCHAR UN
CHASQUIDO DE SUJECICHASQUIDO DE SUJECIÓÓNN
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
With ON/OFF switch facing
the front of the unit, slide
upper handle section over
matching section of the
connector assembly. Insert
shor
t scr
ew into top hole and
long scr
ew into bottom hole
then tighten fir
mly until handle
is no longer loose.
1
2
3
4
9
10
11
14
15
12
13
5
6
7
8
T
o assist you in identifying
components of your vacuum,
the parts have been numbered
as follows
:
1 Handle tube, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
Before assembling appliance,
remove two screws from
connector assembly. Remove
cardboard insert by pulling
upward.
1
Attach cord assembly to cord
clip by pressing cord above
and below clip ensuring the
cord is fully rested in clip.
3