Filter
Top Products
7
Replacing Filter Bag
Check bag frequently or
when bag full indicator has
been activated.
Note: If picking up fine
debris, change bag more
frequently.
Switch the unit off. Unplug
unit from wall outlet. Open
the cover by lifting the
latch in front of the intake.
Remove dust bag by
raising handle on bag
carrier and lifting carrier
out.
Remove the bag from
carrier by pulling the
cardboard tag. The
Saniseal
®
dust seal will
close automatically.
Insert a new bag into
car
rier by sliding
cardboard into slots on
carrier until bag is fully
inser
ted. Bend r
ear par
t of
dustbag downwards.
Replace the car
rier into the
unit.
Close the cover by
pressing it down until it
latches. The cover cannot
be closed if a bag is not
pr
esent or inserted
properly.
BAG FULL
INDICATOR
The standard nozzle is
adjustable for use on
carpets (without brush) or
hard floors (with brush).
To adjust suction, use the
suction control on the
handle.
To adjust power of motor,
use the slide control on top
of unit.
Upholstery tool, crevice
tool and dusting brush can
be found in storage
compartment.
Small accessories can be
used with telescopic wand,
friction wands, or handle
alone.
Note: Under pr
oper
operating conditions the
green indicator light on the
power nozzle will illuminate.
If r
oller brush becomes
stalled, the r
ed indicator light
will illuminate. Remove clog
or source of stall, and press
the red reset button on the
back of the power nozzle to
continue use.
ENGLISH
BARE FLOOR
CARPET
RESET BUTTON
INDICATOR
LABEL