Filter
Top Products
6
Check bag frequently or
when dustbag full indicator
indicates dust bag is full.
Note: If picking up heavy
debris, change bag more
frequently.
Switch the unit off. Unplug
unit from wall outlet. Open
the cover by lifting the
latch in front of the intake.
Remove dust bag by
raising handle on bag
carrier and lifting carrier
out.
Remove the bag from
carrier by pulling the
cardboard tag. The
Saniseal™ dust seal will
close automatically.
Insert a new bag into
car
rier by sliding
cardboard into slots on
carrier until bag is fully
inserted. Bend rear part of
dustbag downwards.
Replace the carrier into the
unit.
Close the cover by
pr
essing it down until it
latches. The cover cannot
be closed if a bag is not
present or inserted
properly.
BAG FULL
INDICATOR
Unplug unit from wall
outlet. Remove the dustbag
and carrier to access the
motor filter grill.
Using the tab located at
top of filter grill, lift filter
grill out of unit.
Remove filter from grill and
replace with new filter.
Change the motor filter
every fifth dustbag
replacement.
Unplug unit from wall
outlet. Remove exhaust grill
from back of unit by
pressing down and pulling
out on the tab located at
the top of the grill.
Discard used exhaust filter.
Place new filter in grill. Set
grill tabs in slots. Press top
of grill to snap closed. The
exhaust filter should be
changed with every fifth
dustbag r
eplacement.
Note: Exhaust filter not
needed if Advanced Hepa
Filter was purchased.
Replacing Motor Filter
Replacing Exhaust Filter
Replacing Filter Bag
ENGLISH