Filter
Top Products
4
Operation
Your Air Purifier works best if you leave it in operation
continuously, and it provides multiple settings for convenient use
at any time.
1.MAIN POWER SWITCH: Turn the unit on by sliding the power
switch to the fan speed you prefer
(fig. 2):
( • • • ) for maximum cleaning
( • • ) for medium cleaning
( • ) for low cleaning
Each setting uses a different fan speed, changing the air flow
through the Collector Cell. Regardless of the setting, the
Collector Cell will continue to clean the air effectively.
2.POWER INDICATOR LIGHT: The indicator light will glow
green when the power is on.
NOTE: You may notice an occasional infrequent sharp
snapping sound coming from your unit. This is a normal
occurrence called “arcing” and results as large particles of
dust are collected in the Electronic Collector Cell. Should
prolonged or continuous arcing occur, the Electronic
Collector Cell should be thoroughly cleaned and dried
completely (See “Cleaning Collector Cell”).
Instructions
WARNING: DO NOT USE THIS ELECTRONIC AIR PURIFIER
WHEN OXYGEN TANKS ARE BEING USED OR IN THE
PRESENCE OF COMBUSTIBLE GASES.
IMPORTANT NOTES:
●
Place or mount the Air Purifier near a standard electrical
outlet. Do not block either the air intake or outlet grill.
●
Never place your Air Purifier on soft surfaces (such as bed,
sofas or carpet), near computers or next to sources of heat
(such as stove tops, ovens, etc.)
●
Make sure the front grill is securely locked in place.
●
A safety switch is installed behind the grill of your electronic
Air Purifier. If the grill is not properly secured in place, the unit
will not operate. If your unit fails to operate, remove the front
grill and reinstall it, being sure that the lower right-hand side
of the grill (next to the control panel) is firmly locked in place.
●
Plug the power cord into the nearest available standard
electrical outlet. (See data label on bottom of your Air Purifier
for electrical specifications and power consumption.)
2
4
3
Buttons
●
Do not use an extension cord to supply power to your Air
Purifier.
Cleaning
The Cabinet
You can clean the Air Purifier cabinet with mild, non-abrasive
cleanser and a soft cloth.
IMPORTANT: Unplug the unit from its
electrical power source. Do not spray cleansers or furniture
polish into louvers or grill areas.
Collector Cell
IMPORTANT: Do not try to clean the Collector
Cell by inserting a cloth, brush, or other
device between the cell plates. The Collector
Cell should be cleaned with Oreck’s Assail-A-
Cell
®
cleaner or using soap and water
(see Step 6. in this section). Inserting objects
in the Collector Cell may damage it.
Oreck recommends cleaning the Collector Cell every four to
eight weeks, or more often if snapping becomes frequent.
Cleaning your Oreck Air Purifier is a snap too... and a must for
efficient operation. To clean proceed as follows:
1.Turn the unit off and unplug it from the electric power source.
If wall mounted, remove unit from wall.
2. Remove front grill by pressing both buttons under the grill on
the cabinet bottom
(fig. 3).
3. Pull the Collector Cell out of the cabinet by using the two
small handles on the front of the Cell
(fig. 4).
4. Snap off the Charcoal Odor Absorber from the back of the
Collector Cell. Change as necessary for continued odor
removal
(fig. 5).
5.Slide off Pre-Filter. The permanent filter should be rinsed off
and reused
(fig. 6).
NOTE: Handle the Electronic Collector Cell with care.
Damaged metal plates and/or broken wires will cause the
Air Purifier to malfunction. (Do not wash Charcoal Odor
Absorber; it is disposable.)