Oreck BB870-QD Vacuum Cleaner User Manual


 
72080-07 REV B ©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used
06/05 ECN# R-8022 under the authority of Oreck Holdings, LLC.
ORECK MANUFACTURING COMPANY: (Oreck 21180 Johnson Road;
Long Beach, MS, USA 39560 gives you the following warranty for this
product only if it was originally purchased for residential use, not resale
from Oreck or an Oreck Authorized Retail Dealer.)
Oreck will repair or replace, free of charge, to the original purchaser, any
part that is found to be defective in material or workmanship within three
(3) years of the date of purchase; ten (10) years on housing. This
warranty applies to normal domestic use. Any commercial use of this
product will void this warranty.
This warranty does not cover the replacement of expendable or
consumable parts such as belts, brushes, bulbs, disposable bags and
other parts subject to normal wear unless they are defective in material or
workmanship.
This warranty does not apply to any part subjected to accident, abuse,
alteration, misuse, damage caused by act of God, the use of voltages
other than indicated on the serial number displayed on this product or
service of this product by other than Oreck or a participating Factory
Authorized Service Center.
Oreck does not authorize any person or representative to assume or
grant any other warranty obligation with the sale of this product.
Oreck’s warranty is valid only if you retain proof of purchase from Oreck
or an Oreck Authorized Retail Dealer for this product. If you purchase this
product from any other source, your purchase is “AS IS,” which means
Oreck grants you no warranty, and that you, not Oreck, assume the entire
risk of the quality and performance of this product, including the entire
cost of any necessary servicing or repairs of any defects.
This warranty is in addition to your statutory and other legal rights.
Reconditioned units carry a 6 month warranty from date of purchase.
WARNING: Unplug cord from electrical
outlet before servicing.
IMPORTANT: Make sure filter bag is in place. Do not operate
cleaner without filter bag. Damage to motor may occur.
• Be sure bag gasket is in place. If the white bag gasket is damaged or
lost, replace at once.
(Part No. 72017-02)
For best results, change disposable filter bag regularly even if it is not
completely full.
An extremely dirty bag or a bag close to full will affect
the suction of the cleaner and can create excessive motor heat that
could damage the motor
.
A
good practice is to change filter bag every
30 days even if it is not full.
Do not pick up moist material or liquids.
If fine materials such as soot, cement, plaster dust, copy machine
powder, etc. are picked up, the bag surface may seal and suction will
be reduced. Change bag when this occurs.
Clean the disposable bag cavity and the outside of the canister with a
damp (not wet) cloth.
IMPORT
ANT
: DO NOT REMOVE
the dirt retaining flap attached on
the back of the front plate. It must be left in place for the unit to operate
properly and to ensure cleaning effectiveness.
ITEM PART #
1. Replacement Treated Filter Bags,
12 pk. with 1 Micro Filter PKBB12DW
2. Replacement Micro Filter 72005-01
3. Replacement White Bag Gasket 72017-02
4. Oreck Fresh Air
®
Tabs AIRTABS
1
2
3
4
5
6
7
8
9
10
ITEM
1. Vacuum cleaner housing with paper filter bag and micro filter
installed
2.
Adjustable shoulder strap
3. Flexible hose with built-in adapter for easy insertion in vacuum or
blower port
4.
Crevice tool
5. Fabric tool
6.
Bare floor and wall tool
7. Tool adapter tube for fitting tools directly to vacuum when not
using hose
8.
T
wo extension wands
9. Dusting brush
10. Tool Caddy
W
ARNING: Unplug cord from electrical
outlet before servicing
CLEANER
WILL NOT RUN
CLEANER
DOES NOT PICK UP
OR HAS LOW
SUCTION
Not plugged in
properly.
No electricity in wall
outlet.
Needs Service.
Filter bag is full.
Hose / Wand tool is
clogged.
Air leak due to
missing or damaged
gasket.
Be sure cleaner is
firmly plugged into
wall outlet.
Check electrical
source–fuse or
circuit breaker.
Take to service
center or call for
nearest service
center.
Replace filter bag.
See “To Replace
Paper Filter Bag.”
Clear obstruction.
Replace Gasket
PROBLEM POSSIBLE SOURCE AREAS TO CHECK
Whenever calling, please be sure to have your model and serial
number from data plate.
CALL CUSTOMER SERVICE HOT LINE
0845 603 0153
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.