Filter
Top Products
1.Not plugged in
properly
2.No electricity in
wall outlet.
3.Motor protector
tripped.
4.Needs service.
1.Filter bag is full.
2.Hose/wand tool
is clogged.
3.Air leak due to
missing or
damaged gasket.
1.Proper friction fit
not being
obtained.
Cleaner Will
Not Run
V
acuum W
ill
Not Pick Up
Or Has Low
Suction
T
ools/Wands
W
ill Not Stay
Together
PROBLEM POSSIBLE SOURCE AREAS
TO
CHECK
Maintenance and Customer Service
Y
our ORECK COMPACT CANISTER VACUUM is a product of
precise engineering. The motor bearings are permanently
l
ubricated and should not be oiled. If you require additional
information or have problems with your ORECK appliance, you
may call ORECK customer service or write to:
T
elephone: 0845 603 0153
Oreck UK
P.O. Box 107
E
xeter
E
X2 8ZQ
Attention: Oreck Customer Service
Please specify the model number and serial/code number which
can be found on the data plate on the bottom of the vacuum.
Save your sales or purchase slip. Should your ORECK
appliance require warranty service in the U.S.A., present this slip
to the Authorized Service Center as your proof of purchase date,
or, in Canada, call customer service.
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
Troubleshooting Guide
1.Be sure cleaner is
firmly plugged into
wall outlet.
2.Check electrical
source–fuse or
circuit breaker.
3.See Motor
Protection System
page 2.
4.Take to service
center or call for
nearest service
center.
1.Replace filter bag.
See “Changing
the Filter Bag,”
page 4.
2.Remove
obstructions.
3.
Replace gasket
See page 4.
1.Push and turn.
Whenever calling, please be sure to have your model and serial
number from data plate.
CALL CUSTOMER SERVICE HOT LINE
0845 603 0153
5