Filter
Top Products
STEP 1: Remove Power Nozzle Assembly
Lay cleaner on flat surface with bottom side of nozzle
(brush side) facing you then:
A) Remove swivel clamp screws and clamp.
B) Remove the two screws at the outer rear corners of the
nozzle base plate only.
STEP 2: Remove Belt
Gently rock rear wheels and base plate up and out of
nozzle. Lift brush roll from holder. Remove old belt and
debris. (Dirt and debris may have been the cause of a
broken belt.)
STEP 3: Install New Belt
Place new belt over end of motor shaft and br
ush roll.
Be Sure Belt Is Not Twisted.
Place br
ush r
oll back into its holder
. Be sur
e flat side of
metal br
ush roll ends are up.
6
To Replace Belt
WARNING: Unplug cord from electrical
outlet before servicing.
CLAMP SCREWS
STEP 4:
Replace Power Nozzle Assembly
Line up tabs in fr
ont of base plate with slots in nozzle
cover
. Press down on front while rocking base back into
place. Be sure front tabs are in lock position. Replace
screws at rear corners. Reattach swivel clamp to nozzle
base.
To order:
Replacement Belts Part No. OR114
Call your authorized ORECK Service Centerr, your
authorized ORECK dealer, or the ORECK Service Center
Hotline toll free at: US: 1-800-989-3535
CANADA: 1-888-676-7325
SCREWS