Filter
Top Products
©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings,
LLC. Printed in
America.
75319-10 REV A
11/05 ECN# R-8058 & 8199
SAVE SERVICE CALLS...CHECK THESE FIRST:
• Is the disposable filter dust bag full?
•
Are pores of filter dust bag clogged with powder or fine dust?
• Is anything clogging the revolving brush, lower tube, intake
opening, fan housing or connector assembly opening?
•
Is the belt in place and turning the brush?
• Are the brush ends in the proper location?
• Does the brush turn freely? Are hair, string or rug fibers wound
around the brush?
CLEANER
WILL
NOT RUN
CLEANER
DOES NOT PICK UP
Not plugged in
properly.
No electricity in
wall outlet.
Filter bag is full.
Nozzle or intake
pivot clogged.
Belt is broken or
stretched.
Brush is worn.
Bag tube clogged.
Bag pores are
clogged with fine
dust.
Impeller fan is
br
oken.
Revolving brush is
not even at both
ends.
Be sure cleaner is
firmly plugged
into wall outlet.
Check electrical
source–fuse or
circuit breaker.
Replace filter bag.
See “To Replace
Paper Filter Dust
Bag.”
Clear obstruction.
Replace belt.
See “To Adjust or
Replace Brush.”
Clear obstruction.
Change bag.
Return to Service
Center for r
epair
.
Check brush roll
end cards. Make
sure words “OLD”
or “NEW” match
at each end.
PROBLEM POSSIBLE SOURCE AREAS TO CHECK
Whenever calling, please be sure to have your model and
serial number from data plate.
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SER
VICE CENTER.
WARNING: Unplug cord from
electrical outlet before servicing.
COMMERCIAL CUSTOMER SERVICE
(0) 01279 406995
IMPORTANT: On plush and new carpets, stuffing may occur
due to excessive fuzz and loose cuttings in the carpet.
Stuffing could occur for the first few cleanings until all the
loose material is removed. Due to the high efficiency of the
cleaner, many older carpets will cause stuffing when the
cleaner is first used on them.
NOTE: If the Stuffing or Blockage instructions do not correct the
problem, contact an ORECK Authorized Service Center or call
the Commercial Customer Service Center at (
0) 01279 406995.
5. Many times blockage occurs
due to a full dust bag
causing dirt to back down
the air flow system. When
that happens, the blockage
will be at the top of the
system, starting in the area
where the dust bag connects
to the connector assembly.
See illustration F.
F
Connector
Deflector
Opening
Stuffing or Blockage
Troubleshooting Guide