Filter
Top Products
20 Quadra-Fire • Topaz • 7009-113 Rev. J • 12/11
4. Existing Masonry Chimney
Type A - Up & Out Installations for Top Vent
Configurations
Figure 5.24
Type B - Hearth Rear Vent Installations for Use With
Rear Vent Kit (see Section 12 for conversion kit and
venting components.)
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear Connector
3 in. (76mm)
Flex Liner
Pipe Length
Optional
Chimney Liner
Termination Cap
Co-Axial to
Co-Linear
Connector
30 ft. (9m) of 3 in.
(76mm) Flex Liner
Exhaust Section
Pipe Length
Optional
4 ft. (1m) of 3 in.
(76mm) Flex Liner
Air Intake Section
The chimney must be sealed
from the 4 ft. (1m) section to
termination using a smoke
shelf or a damper.
The seal should be 6 in.
(152mm) below the end of the
4 ft. (1m) Air Intake section.
This section of the
chimney must be
sealed
Termination Cap
Flashing
4 in. (102mm)
Flex Liner
Top Adaptor
Retro Connector
90° Elbow
Direct Vent Pipe