Filter
Top Products
Step 3 In Installation of wall plate (continued)
Mounting to solid wood or wood studs.
Drill a pilot hole into center of each location using 3/32" drill bit (provided).
Drill 1-1/4'' into the stud.
Attach wall plate with two #8 x 1-3/4" wood screws.
fig. 4
wall
wall
fig. 5
wall
fig. 6
fig. 14
fig. 15
Set screw location
Set screw location
extension
Set screw locations
Screw covers
Step 5 I Installation of adjusting knuckle and
extension.
OmniMount Systems, Inc.
The Pointe at South Mountain
8201 South 48th Street
Phoenix, Arizona 85044-5355
Toll free 1-800-MOUNT-IT
(480) 829-8000
Fax: (480)756-9000
email: info@omnimount.com
Copyright 2004 OmniMount Systems, Inc. All
rights reserved. OmniMount products are
covered by patents issued and/or pending.
“OmniMount” is a registered trademark of
OmniMount Systems, Inc. "Audio Basics" is a
trademark of OmniMount Systems, Inc.
AB-2 revision 2, 1/04 Part #1000254. Printed
in the U.S.A.
100% Replacement Warranty
Audio Basics products are engineered and manufactured to the highest standards. In the event that there are defects in materials,
workmanship, or missing parts, OmniMount Systems will, at its discretion, repair or replace your Audio Basics product. Claims that are
submitted must include either the sales slip or proof of purchase.
If OmniMount products are used for purposes other than their original intent, OmniMount Systems, its distributors and retailers shall not be
held responsible or liable for injuries or property damage, direct, indirect or consequential, which may arise from the inability to use this
product safely, properly, and in the manner for which it has been designed and manufactured.
This warranty does not apply to products which have been lost, damaged by misuse, abuse or accident, altered or repaired in any way other
than specified by OmniMount Systems, Inc.
This warranty is non-transferable.
For installation assistance please call our toll free help line at 1-800-MOUNT-IT
fig. 13
#8 x 1-3/4"
Step 4
Installation of radius plate, button stud plate or
mounting plate onto speaker.
3. Speakers without mounting holes - wood cabinet only.
fig. 1 fig. 2
fig. 3
fig. 4
#8 x 3/4''
3/32'' drill bit
1. Speakers with one threaded insert (fig. 1) or Bose
®
series (fig. 2).
2. Speakers with single keyhole in back. Insert assembly (fig. 3) into
keyhole and slide upward -then tighten (fig. 4).
4. Speakers with 1/4"-20 insert on back.
®
1/2"
fig. 1
fig. 2
fig. 3