Filter
Top Products
keypod
to store this value into memory.
4-1
3-2
value.
When the desired value is showing in the display, press the
CAL/ENTER
value
to the
desired
displayed
A
keys to change the
4
ond
the
panel.
Use
Iit
on the
front
keypod,
until the Lo onnunciotor is
SET/TEMP
Setpoint
Value:
Press the
v&e
into memory.
To Enter the lo
k
store this
keypod
display,
press the
CAL/ENTER
value
to the
desired value.
When the desired value is showing in the
displayed
change
the
A
keys to
4
and
annunciator
is lit on the
front ponel.
3.
4.1. 2
1.
2.
3.
Use the
Setpoint
Value:
Press the SET/TEMP keypad, until the Hi
pH buffer 4.01 or 10.01. Press the CAL Key.
4.1. 1
At this time the “CAL” annunciator light will appear. When the
light goes off, the slope is calibrated.
1.
2.
To
Enter the Hi
Setpoints
Hi/Lo
4.1 Entering PHCN-410
stondord
place
the electrode
in
water
ond
electrode with distilled
pH buffer 7.00. Rinse
the
pH
electrode from the
4.
Remove the
pH
Electrode
Operating the Controller
Calibrating the