Filter
Top Products
Setting Up the Pump(s)
3
3-3
1. Refer to Figure 3-1. Make sure the pump is in the closed position.
2. Refer to Figure 3-2 and Figure A. Place the blade of a flathead
screwdriver in the groove of the Rotor Shaft (5). Rotate the Rotor
Shaft until its back tab slips into the groove of the motor shaft. Do
not try to force the pump onto the motor until you perform Step
#3.
3. Refer to Figure 3-3 and Figure A. Swivel the pump back and forth
slightly to align the holes on the back of the base (8) with the
alignment pins on the face of the motor. Press the pump base up
against the face of the motor.
4. Refer to Figure 3-4. With the pump and motor aligned, insert the
mounting screws through the mounting holes in the pump, until
they make contact with the threaded mounting holes in the face of
the motor.
5. Tighten the screws fully with a
9
⁄64 (M3.5) allen wrench.
Parts of the Pump
Figure A
5
8
(Base)
(Rotor Shaft)