Filter
Top Products
1. Install monitor as high as possible without raising glass.
2. Screen should point slightly above user's face (bottom edge of
monitor is nearer to the eye than top edge).
3. Preferred position: top edge of monitor is at back edge of glass.
Determine the modification necessary to accomplish the
preferred viewing angle. To make angle adjustments, move
either the top or the bottom Tracking Block assemblies
independently of each other. For standard-size monitors, a good
starting point is 4 spaces up in front and 5 spaces up in back.
Monitor Adjustment
Maximum Monitor Dimensions:
17-1/2"D x 17"W x 18"H
Downward Gaze
™
Monitor Installation
Step 10.2
Once the angle is adjusted, adjust the height by raising or
lowering both upper and lower Tracking Block assemblies the
same number of spaces.
Step 10.3
After you achieve the desired height and angle, you can fine
tune the viewing distance by sliding the carriage forward and
backward. Each time you make an adjustment, reinsert the Male
Tracking Blocks. When the adjustment is completed, install the
Security Screws. The bottom of the screen should always be
closer to your eyes than the top.
Step 10.4
Page 4
Too Low!
...Monitor is located too
far below glass so that
view is obstructed.
Wrong Angle!
...Top of monitor is closer
to the eye than the
bottom of the monitor.
PATENT INFORMATION: Nova products are covered by one or more of the following U.S. patents: Re. 34,266; 4,869,564; 5,125,727; 5,290,099; 5,294,193 & 5,408,939.
Other U.S. and foreign patents issued and pending.
Correct Installation
Incorrect Installation
50-0-1818 Asy. Instr. © Nova Solutions, Inc. 2002
K
eyboard drawer from
edge of top
7
9
/
16
"(1st Stop)
10"(Last Stop)
3-
5
/
8
"
5-
1
/
2
" to
7-
5
/
8
"
22-
7
/
8
"
19-
5
/
8
"
12-
11
/16" 12-
13
/16"
14"
25-
1
/
2
"
LOWER
TRACKING
BL
OCK
UPP
ER
TRACKING
BLOCK
TR
ACKING
BL
OCK-F
SECURITY
SCREW
TRACKING
BLOCK-M
LOWER
TRACKING
BLOCK
UPPER
TRACKING
BLOCK