Filter
Top Products
• Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrig-
erators. There is an increase risk of electric shock if you body is grounded.
• When operating a power tool outside, use an outdoor extension cord marked “W-A” or
“W”. These cords are rated for outdoor use and reduce the risk of electric shock.
• Extension Cord Use.
A. Use only 'Listed' extension cords. If used outdoors, they must be marked “For Outdoor
Use.” Those cords having 3-prong grounding type plugs and mating receptacles are to be
used with grounded tools.
B. Replace damaged or worn cords immediately.
C. Check the name plate rating of your tool. Use of improper size or gauge of extension
cord may cause unsafe or inefficient operation of your tool. Be sure your extension cord
is rated to allow sufficient current flow to the motor. For the proper wire gauge for your
tool, see chart.
CHART FOR MINIMUM WIRE SIZE OF EXTENSION CORD:
If in doubt, use larger cord. Be sure to check voltage requirements of the tool to your
incoming power source.
• Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
• Do not let your fingers touch the terminals of plug when installing to or removing from
the outlet.
• Ground fault circuit interrupters. If work area is not equipped with a permanently
installed Ground Fault Circuit Interrupter outlet (GFCI), use a plug-in GFCI between power
tool or extension cord and power receptacle.
PERSONAL SAFETY
• Stay alert,
watch what you are doing and use common sense when operating a power
tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating power tools may result in serious
personal injury.
• Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair,
clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be
caught in moving parts. Air vents often cover moving parts and should be avoided.
• Use safety apparel and equipment. Use safety goggles or safety glasses with side
shields which comply with current national standards, or when needed, a face shield. Use
as dust mask in dusty work conditions. This applies to all persons in the work area. Also
use non-skid safety shoes, hardhat, gloves, dust collection systems, and hearing protec-
tion when appropriate.
•
A
void accidental starting.
Do not carry the power tool with your finger on the switch.
Ensure the switch is in the of
f position before plugging tool into power outlet. In the event
of a power failure, while a tool is being used, turn the switch of
f to prevent surprise starting
when power is restored.
3