Filter
Top Products
INSTALLATION
RECEIVING & UNPACKING EQUIPMENT
1. Check packing slip to ensure ALL material has
been delivered.
2. All material shortages are to be reported to
NORTEC within 48 hours from receipt of goods.
NORTEC assumes no responsibility for any
material shortages beyond this period.
3. Inspect shipping boxes for damage and note on
shipping waybill accordingly.
4. After unpacking, inspect equipment for damage
and if damage is found, notify the shipper
promptly.
5. All NORTEC products are shipped on an F.O.B.
factory basis. Any and all damage, breakage or
loss claims are to be made directly to the
shipping company.
PRE-INSTALLATION CHECKPOINT
1. Ensure that available voltage and phase
corresponds with humidifier voltage and phase
as indicated on humidifier’s nameplate label.
2. Ensure that the dedicated external disconnect
switch is of sufficient size to handle the rated
amps as indicated on the nameplate label. Refer
to local codes.
3. Report any discrepancy immediately.
HUMIDIFIER CONFIGURATION
To avoid any danger, never operate the
humidifier with a door off.
To open the door, use the key to unlock, lift door
up slightly and pull door forward.
LOCATION & MOUNTING
HUMIDIFIERS
RESDELUX Series humidifiers are designed to
mount on a suitable wall or vertical surface. Do not sit
on the floor due to additional clearances required for
plumbing, electrical, and control access holes. The
clearance dimensions shown in this manual are for
reference only and are the minimum required for
maintenance of the humidifier. Local and National
Codes should be consulted prior to final location and
installation of the humidifier. Walter Meier (NORTEC)
does not accept responsibility for installation code
violations.
1. Location of the humidifier should be below and
as close as possible to the steam distributor
location or blower pack. Net output will be
reduced as a result of heat loss through long
steam hose.
2. See Figure #2 for front clearance requirements
for access during installation, maintenance and
troubleshooting.
3. Where possible, mount humidifier at a height
convenient for servicing.
4. To mount the humidifier use two #8 screws, 2”
long, and secure into a standard 2”X4” wood
stud or equivalent structure.
-1-
PowerAnd
Control
Wiring
Drain
Water
Supply
Nameplate
Label
Condensate
Return
Steam
Outlet
Figure #1
RESDELUX Series Humidifier
W
a
ll
Min.36"
Frontal
Clearance
NOTE: Localandnational
codesmaydeviate. Please
consultapplicablecodes
forclearancerequirements
Figure #2
Clearance Requirements