Filter
Top Products
AireCare
Electronic
Air Filter
Grille
Protective
Edging Strips
Upper
Bracket
Lower
Bracket
Figure 1. M1 Bracket Installation
E2 AireCare TM Electronic Air Filter
installation Instructions
(2-4 Ton A/C)
Before starting this installation, make sure that
all electrical power to the furnace has been
disconnected.
The E2 electronic air filter kit consists of one
filter bracket, two screws, and the electronic air
filter with power cable.
Install the Brackets
1. Remove the grille from the top of the
furnace.
2. As shown in Figure 2, place the filter bracket
into the grille frame and attach using the
two screws provided.
Install the Electronic Air Filter
1. Connect the electronic air filter power wires
(24 VAC) to the red and gray (or black) low
voltage terminals (R and C) in the E2
furnace. Connect the power wire marked
with a white stripe or dash to C, the other to
R.
2. Place the filter into the filter bracket and con-
nect the filter power cable by plugging it into
the connector located at the top of the filter.
3. Turn on power to the furnace. The
AireCare TM Electronic Air Filter is active
if the light on top of the electronic air filter
is lit.
4. Replace the grille.