Filter
Top Products
11
PIPING DIAGRAM WITH UV-LIGHT
REMOVE COMPONENTS FROM BASIN AND ASSEMBLE AS SHOWN. THE FITTINGS REQUIRED ARE ALREADY ATTACHED
TO THE FILTER AND BASIN. WHEN USING THE OPTIONAL UV-LIGHT, THE BARBED ELBOW FITTING ON THE ‘IN’ SIDE OF THE
FILTER WILL NEED TO BE REMOVED AND THREADED INTO THE ELBOW AT THE BOTTOM OF THE UV-LIGHT. THEN CON-
NECT THE UV-LIGHT DIRECTLY TO THE FILTER. USE TEFLON TAPE TO SEAL THESE CONNECTIONS. ENSURE THAT THE
SUPPLIED GROUND WIRE IS CONNECTED FROM THE GROUNDING TERMINAL ON THE UV LIGHT TO EITHER GROUNDED
COPPER PLUMBING, OR THE GROUND IN YOUR ELECTRICAL SYSTEM. USE THE SUPPLIED SHORT PIECE OF BLACK
TUBING TO RUN FROM THE PUMP TO THE UV LIGHT. MEASURE AND CUT THE LINES TO THE LENGTH NECESSARY, PUSH
ONTO THE BARBED FITTINGS AND SECURE WITH THE SUPPLIED HOSE CLAMPS. LEAK TEST THE WATERFALL BEFORE
FULLY ENCLOSING.
B
A
FROM WATERFALL
DRAIN TO BASIN
FROM THREE
WAY VALVE TO
WATERFALL
TO
ELECTRICAL
OUTLET
1
3
2
4
9X
N570-0043 (8-32 X 3/4")
FROM BASIN TO
WATERFALL DRAIN
OVERFLOW
PROTECTION
PURGE LINE
FROM WATER
SOURCE TO
FLOAT VALVE
B
A
TO DRAIN
FROM THREE WAY
VALVE TO WATERFALL
SADDLE VALVE
FLOW CONTROL
VALVE / PURGE
VALVE
INSTALLTHE SUPPLIED
HOSE CLAMPS ON EITHER
SIDE OF THE BASIN
WATER
FILTER
UV
LIGHT