Filter
Top Products
12
W415-0098 / C / 04.19.06
Follow the instructions for "Wall and Ceiling Protection".
ADAPTER INSTALLATION FIGURE 23
1. Remove the spill switch bracket from the rear of the
adapter.
2. Gently pull the two wire terminals (located inside the 7"
flue collar at the top of the stove) out approximately 8
inches.
3. Bring the wires through the lower hole in the adapter and
out the spill switch opening. To pass the wires through the
hole more easily, temporarily tape the two terminals to-
gether.
4. With the spill switch opening aligned to the back of the
stove, take hold of the adaptor base and push the crimped
edge into the stove flue collar.
5. Connect the wire terminals to the spill switch and re-
secure the bracket.
For aesthetics, the adapter has been designed to accept
a standard matte black 7" stove pipe and the Napoleon
decorative brass band (standard with the GS150KT). Both
are available from your Napoleon dealer.
For ease of assembly, a
7" telescoping stove pipe
may be installed over the
4" vent connection of the
adapter. Add vent sections,
twist locking (clockwise)
securely, to the required
height. The vent should ex-
tend, at least, 3 feet above
its point of contact with the
roof and, at least, 2 feet
higher than any wall, roof
or building within 10 feet.
FIGURE 24. (This is a guide-
line only; local venting
codes should be followed
which may differ in height
and clearance require-
ments.)
Three types of chimney systems may be used
with this stove:
A CHIMNEY VENTING THIS STOVE SHALL NOT VENT
ANY SOLID FUEL BURNING APPLIANCE.
ALL HORIZONTAL RUNS MUST HAVE
A 1/4 INCH RISE PER FOOT.
FIGURE 22
SWITCH
SPILL
ADAPTER
FIGURE 23
FIGURE 24
B-VENT SPECIFICS - MODEL GS50
CHIMNEY INSTALLATION INSTALLING 'B' VENT:
ADDING VENT SECTIONS