Filter
Top Products
6
WF6
WF9 WF18
70.50”
35.50”
35.50”
35.250”
23.625”
35.250”
TILES
MORTAR
BACKBOARD
TILES
MORTAR
BACKBOARD
TILES
MORTAR
BACKBOARD
CLEANING AND MAINTENANCE
The waterfall should be drained and cleaned every 3-4 months, possibly more depending on the quality of the water. The water-
fall surface can be cleaned using a warm soap and water mixture. Do not use harsh abrasive cleaners on the surface of the
stainless steel panel or it will permanently scratch the surface. Any wiping motion should be done in the direction of the grain. If
small scratches do occur, they can be blended out by gentle rubbing in the direction of the grain with a Scotchbrite pad.
The water should be completely flushed and drained from the system - switch the valve to
the purge setting, and run the pump to pump the water out. Refill the tank, run the water
through the fountain for 3 minutes and purge again. If calcium or hard water deposits are
forming on the panel or anywhere else in the system, cycle CLR solution through the system
until the deposits are removed then purge the system a few times with water.
If there are spots on the panel that dry out, check that there are no blocked ports in the
manifold tube. Remove the three nuts that secure the tube cover, and remove the cover. Re-
move the tube by flexing it out in the centre. This will allow the ends to pull out. Poke the holes out
with an opened paper clip, and then flush the tube with water. Clean the angled surface that the
manifold sprays onto with liquid TSP (or TSP substitute). It is critical that this surface is extremely
clean. Install the tube back into the unit, with the ports aiming straight down and refill with water.
Install the tube cover and test the unit.
CUSTOM SURFACE PANEL: Panels can also be made using materials such as mirror,
glass, slate, marble or ceramic tile for display in your waterfall. If tiling, use waterproof cement
board as a backer, available at any building centre. Cut the cement board to the size of your
existing stainless steel panel. Ensure that the tiles can be used in a wet environment. Porce-
lain tiles are recommended. Tile the surface, using thinset mortar, as you would a ceramic tile
floor or bathroom wall. It is not necessary to leave a gap or grout line in your tile. Ensure that the
bottom edge of the tiles are flush with the bottom edge of the cement board. You can choose any colour
or pattern that you like, to match the room or surroundings. The water will flow over the tiles, just as it does on the stainless steel
panel, but be sure to keep the edges of the tiles fairly flush to each other to prevent the water from splashing off. Surfaces less than
3/8” thick, such as glass or mirror, can be installed in front of the stainless panel. The stainless panel must be removed for all panels
thicker than 3/8” up to a maximum of 3/4”. Do not use glue to attach the tiles to the back panel, as some types of glue or epoxy will
leach out into the water, causing the filter and manifold to plug.
VALVE
PURGE POSITION
TO DRAIN
TO FOUNTAIN
FROM BASIN
TUBE COVER
MANIFOLDTUBE
The sediment filter should be replaced every 3-4 months. To replace, unplug the pump. Lay a towel under the filter housing, as
water will drain out of the housing when opening. Unscrew the housing, and remove the filter. Replace with a new filter (part
#N252-0001) available through your authorized NAPOLEON dealer. Push the new sediment filter firmly onto the collar in the
bottom of the housing. Screw the housing back onto the unit. This must be screwed on very tightly, or it will leak.