Filter
Top Products
PAGE 18 — ST-2005 SERIES SUBMERSIBLE PUMPS — OPERATION & PARTS MANUAL — REV. #3 (09/21/04)
ST-2005 SERIES SUB. PUMP — CLEAN-UP
Pump Shut-Down/Clean-up
1. Remove the power from the pump by turning off the circuit
breaker or switch that provides power to the pump. Remem-
ber to make sure that hands are dry (not wet), and feet are not
standing in water when removing disconnecting power from
the pump.
2. Using the lifting rope, lift the pump up from its current position.
Remove the discharge hose from the discharge port on the
pump.
3. Remove all power cables and float switches from the control
box. Place cables and float switches in a suitable container
where they will not get damaged.
4. If the pump was used to pump mud, grit or silt, flush vigorously
with clean water.
5. Remove the pump from the water. Wipe off any mud or debris
that might have attached itself to the pump.
6. Store pump in a clean dry place away from dirt and debris.