Morphy Richards VC73215 Vacuum Cleaner User Manual


 
66
FILTERS
Cleaning the pleated
filter
You should clean the pleated
filter each time the product is
emptied.
1 Use the small brush Ô
provided (located on the filter
assembly) to remove any fluff
from the outside of the mesh
filter F.
2 Rotate the mesh filter Ó
clockwise to release the mesh
filter and pleated filter Ì
assembly from the filter holder
G.
3 Lift out the pleated filter Ì then
empty out the dust from the
mesh filter Ó into the bin.
4 Re-assemble the filter assembly
by placing the pleated filter
inside the mesh filter, then place
the filter holder on top in the
correct position. Rotate the
mesh filter assembly
anti-clockwise to lock the
assembly together H.
5 Place the filter assembly back
inside the dust canister, making
sure the filter assembly is
placed level and that the filter
holder seal is seated neatly.
6 Re-attach the dust canister to
the cleaner by hooking the
bottom of the dust canister in
first, then closing the canister
until it clicks and the canister
release catch is fully down
and secured I.
If there is resistance when
you re-fit the canister onto
the cleaner, remove and
carefully reseat the filter
assembly back into the
canister, ensuring the filter
assembly seal is located
fully and neatly.
Washing the pleated
filter
For total cleaning of the pleated
filter, it should be washed with
warm water with no detergents.
Allow the filter to air dry.
IMPORTANT: The filter must be
completely dry before re-fitting.
Motor protection filter
This cleaner is fitted with a
motor protection filter.
IMPORTANT: NEVER USE THE
VACUUM CLEANER WITHOUT
THIS IN PLACE.
Cleaning the motor
protection filter
1 Remove the filter from the
filter grille J.
2 Rinse the filter in luke warm
water and dry the filter
completely.
3 Put the filter back into the filter
grille and reassemble.
I
J
H
UUKK HHeellpplliinnee 00884444 887711 00994499 RReeppllaacceemmeenntt PPaarrttss 00884444 887733 00771155 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
G
F
73215 rev3 30/9/08 13:33 Page 6