Filter
Top Products
4
Assembly
To use as an upright
A
1 Fit the floor nozzle by pressing in the locking
pin and insert the nozzle into the hole at the
base of the body
D. Push down fully.
2 Locate the telescopic handle into the body
by pushing in the locking pin and lowering
the handle in until the locking pin locates in
the locking hole
E. To remove, press in the
release button
⁄ and lift the handle out.
3 Adjust the telescopic handle by sliding the
button
‹ down and pulling out or pushing
in the lower half
F.
To use as a handheld
B
1 Remove the telescopic handle.
2 Remove the floor nozzle by pressing in the
release button
Ï and pulling the floor
nozzle away from the body
G.
3 Slide the hose end
Ë from the hose end
location
Á. H
4 Fit the extension tube to the hose end
Ë.
5 Fit the crevice tool Ò to the extension tube.
6 If required fit the brush
Ú to the end of the
crevice tool.
Attachments
Uses for the brush attachment include
stairs, upholstery, mattresses, curtains and hard
surfaces like door mouldings and skirting
boards. The crevice tool is particularly useful for
cobwebs and in narrow gaps in the car around
the handbrake and seat.
E
‹
D
F
H
G
73090 Rev 1 28/4/04 5:42 PM Page 4