Filter
Top Products
Quick start
1 Assemble the nozzle, telescopic tubes and
hose as shown
A.
2 Pull out the mains cable to it’s full length
and plug in to the mains supply.
3 Switch on by pressing the foot pedal
fi.
Accessories
1 Fit the hose to the cleaner by inserting the
hose end into the hose inlet
⁄. When
removing, squeeze the clips either side and
pull.
2 Attach the telescopic tubes to the handle
end of the hose. Extend to the required
length by pressing down the slider release
Ê and pulling out the tube B.
The hose handle features a regulator
È
which allows the suction to be reduced as
required.
3 Attach the combination floor nozzle
 to
the tubes.
The crevice tool (for awkward places,
behind radiators etc.) and the upholstery brush
(for curtains and upholstery) are stored on the
tubes. The crevice tool has a flip-action brush
attachment for hard surfaces, pelmets, delicate
objects etc C.
Controls
Power
The on/off control is operated by the foot
pedal
fi.
Variable power control
A rotating dial ‡ varies the suction power
as required. For example, maximum suction
can be used for cleaning carpets, hard floors
etc. and reduced suction for cleaning
upholstery and curtains.
Suction can also be controlled using the
airflow control on the handle
È. Closed for
maximum suction, open for reduced suction.
Automatic cable rewind
After use, unplug and press the cable
rewind button › to retract the cable.
WARNING: When using the cable
rewind, always hold the plug as the cable
will rewind quickly.
B C
Á
Ê