Filter
Top Products
Using
IMPORTANT: Please remember that the
steam cleaner operates by emitting steam at
an increased temperature of 130˚C. Never
use it on objects or surfaces which cannot
resist this temperature, delicate materials,
dralon, plastic, natural fur etc. Where any
doubt exists check carefully on a part of the
material where minor marks will not matter.
Filling the boiler
E
Ensure the steamer is unplugged from
the mains supply before filling or re-filling.
1 Unscrew the filler cap › by pressing
down and turning anti-clockwise.
2 Fill the boiler with a maximum of 1.0 litres
of water by using the jug and funnel
provided. Warm water may be used
which will r
educe the heat-up time. Do
not use any detergent.
3 Refit the filler cap and fully tighten by
pressing down and turning clockwise.
WARNING: The filler cap must never
be opened during use.
IMPORTANT: The use of any other fluids
can be dangerous and can lead to damage
o
f the heating element.
Re-filling the boiler
WARNING: Always switch off, unplug
from the mains supply and release all
steam before opening and removing the
filler cap.
1
Release the steam pressure by pressing
the steam trigger Ê on the handle until
all the steam has been expelled F. Leave
the steamer to cool down for a few
minutes.
2 Fill the boiler as previously.
• Use warm water to reduce the risk of
spitting.
Switching on
1 Insert the plug into the power socket.
2 Switch the cleaner on by pressing the
on/off switch
fl to ‘on’ G. The red
power indicator light ‡ and the orange
thermostat indicator light · will
illuminate. It will take approximately
5
D F
E G