Filter
Top Products
5
Tool storage
C
The upholstery nozzle Ï, and
the crevice tool Ì and brush
attachment Ó may be stored
on the tube using the clip holder
Ô.
Switching on
Always pull out the supply cable
to it’s maximum length. Plug the
appliance into the mains supply.
Ensure that the Eco Switch „ is
set to the required setting before
switching the cleaner on D.
Push the on/off switch ‚ to
start the motor.
Controlling suction
power
The suction power can be varied
to suit the surface being
cleaned, by using the Eco
Switch „ E, see table for
guideline settings.
The suction power can also be
adjusted using the fingertip
control on the handle Û F.
Closed: full suction
Open: reduced suction
Recommended
settings
Alter the power setting to suit
the surface (as shown in the
table, left).
Dustbag full indicator
If the indicator is permanently
fully red, the bag is full. If the
bag does not appear full, check
for blockages and clean the
filters.
Please note: the indicator will
occasionally go red during use,
this is normal.
Eco Switch Power setting Application
Curtains and
delicate fabrics
Textiles and
upholstery
Floor coverings,
such as rugs,
economy setting
for carpets
Carpets or hard
floor coverings
wwwwww..ggoobblliinn--vvaaccuuuummss..ccoomm
D
E
„
Close Open
C
F
73276 rev1 30/9/08 13:21 Page 5