Filter
Top Products
P
lace floating brackets onto blades aligning
holes in blade with the floating bracket.
P
lace blade arms onto the other side of the
blade and aligning holes. Insert screws with
fabric washers though the holes and tighten
s
ecurely.
Connect plug from fan to switch house plug.
20
21
25
Lift Canopy to ceiling aligning the key hole slots
w
ith the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
t
he Canopy. See inset for Keyhole shape
19
Loosen 3 screws with slots and remo
v
e 2 with-
out slot. Place switch housing over 3 screws
and twist into place. Tighten the 3 screws with
slots and replace and tighten the 2 remo
v
ed.
26
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. The
screws, washers, and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely.
22
Loosen 4 screws with slots and remove the
other screw.
23
Place fitter plate on screws and twist into place.
Tighten the 4 screws with slots and replace the
other screw.
24