Monte Carlo Fan Company 5SLR52 Fan User Manual


 
A
ttach glass b
y locating dimples in
light kit with the gro
ves in glass and
twist clockwise till tight.
30
Connect plug from fan to switch
house plug. (as shown)
26
Make wiring connections for remote
receiver to fan as above diagram.
21
Carefully snap flurescent lamp into
clips.
29
Attach blades to motor using screws
and washers in hardware bag and
tighten screws securely.
24
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
25
Install light plate with ballast to fan
b
y twisting plate with k
ey hole slots
into place. Replace screw removed
and tighten the 3 screws securely.
27
Plug ballast into the flourescent
lamp
.
28
Ready for wiring
19
Lift canopy and install knurled nuts as
shown. Tighten the knurled nuts securely.
The canopy should adjust for any irregu-
larity in the ceiling or Outlet box.
23
Make wire connections to power source using
wire nuts prov
ided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
22
C
onnect black from remote receiver to black or
(
hot) wire from house. Connect white wire from
r
emote receiver to white (neutral) wire from
h
ouse. Connect green ground leads from
mounting bracket and downrod to ground lead
from house. Refer to Safety Tips section of
manual.
20