Filter
Top Products
Loosen 3 screws and remove 1 screw
on light plate as shown. Save screw.
R
emove finial nut and finial cap from
light kit.
34
39
Plug connector from fan to connector
from switch housing.
41
Tighten switch housing screws.
42
Twist lower cover plate into place by
twisting in direction of arrow.
R
eplace 1 screw removed and tighten
all 3 screws securely.
33
Attach blades to motor and tighten
screws securely using screws, washers
and motor pads in hardware packs.
31
Loosen 2 screws and remove 1
screw. Save screw removed.
32
Install all thread into switch housing.
36
Remove plug from switch housing.
35
Install lockw
asher and hex nut pro-
vided and tighten securely.
38
Install finial cap and finial nut onto
switch housing.
40
For light kit go to step 44
Install nut to all thread into switch
housing.
37