Filter
Top Products
5ML52-CUL-ENG
C
arefully lift fan assembly onto mounting
b
racket. Rotate fan so that the notch on the
ball engages the ridge in the mounting bracket.
T
his will allow hands-free wiring.
8
7
Attach blade brackets to blades using the blade
br
acket screws and washers provided.
14
After attaching blades,; reinstall the switch
housing using the three screws previously
removed.
16
Make wire connections to power source using
w
ire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
10
For pullchain controls, follow diagram above.
M
ake sure that all exposed wiring is secured
i
nside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
11
B
lack
W
hite
Green
B
lack
White
Green(downrod)
G
reen(Bracket)
Blue
For control of fan and optional light from wall
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
12
For Canadian installation and for USA fan and
l
ight kit combinations over 35 lbs, in both flush
a
nd downrod mode the safety cable must be
installed into the house structure beams using
t
he 3” lag screws provided. Make sure that
w
hen the safety cable is fully extended the
leadwires are longer than the cable and no
s
tress is placed on the leadwires.
9
S
afety cable installation
Safety Cable
Lag Screw
Check the motor for plastic shipping stabiliz
er
tabs, and remove them if they are present. The
screws, washers and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely
.
15
Raise the canopy up and align the two holes in
the canop
y with the two holes in the hanger
bracket. Secure with two screws provided.
13
T
ighten both yoke set screws to further secure
downrod.
Light Switch
Fan Switch
Wall
Control