Filter
Top Products
Install wall control unit to outlet box
using machine screws provided.
29
A
ttach front co
ver to wall control
with screws pro
vided.
Twist lower cover plate into place by
t
wisting in direction of arrow.
Replace 1 screw removed and tighten
all 3 screws securely.
21
30
The screws, washers and motor pads are
pre-installed to the blade holders. Attach
blade assembly to motor and tighten
screws securely.
19
Remove cover by snaping off from
top or bottom. Install 12V battery
into wall remote. Duracell MN21 /
Eveready A23 / GP 23A all 12V.
27
A
ttach co
v
er of remote b
y placing
o
v
er buttons and snaping into place.
28
Loosen 3 screw on light plate as
shown.
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
22
23
Place glass on light kit, hold in place
and tighten finial cap in direction of
arrow.
26
Install the 3 x 40 w
att incandescent
candelabra bulbs.
25
Place light kit over screws and twist
direction of arrow into place. Then
tighten all 3 screws securely.
24
L
oosen 2 screws with key slots and
remove the 1 screw with closed slot.
Save screw removed.
20