Filter
Top Products
R
aise fan with downrod assembled to
the ceiling bracket and hang fan
assembly. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
14
Align hole in downrod with hole in
yoke and install cross pin. Install
downrod into yoke. Install keeper
into cross pin.
12
Tighten 2 downrod set screws and
lock nuts.
13
Install remote receiver by sliding into opening in
the Mounting br
acket. Make sure that the dip
switches on the T
r
ansmitter and the R
eceiver
are set to the same position. See Fig 34 for
remote operation
17
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3” lag screws,w
ashers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
15
Safety cable installation
Safety Cable
Lag Screw
safet
y
cable
3” lag
screw
lock
w
asher
washer
Mak
e wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote mark
ed
light. Black from fan to Black from remote
mark
ed L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
white
black
18
Remove upper motor housing.
7
Place blades in the side slots of the
motor. Line up the 3 holes and install
washers and screws securely.
8
Replace upper motor housing.
9
Align the 6 holes on the yoke and
replace with the screws saved from
earlier step. Tighten securely.
10
Slide canopy and yoke cover onto the
downrod. Thread the leadwires and
safety cable through the downrod as
shown.
11
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one tr
ansmitter b
y setting both
receiv
ers the same as the tr
ansmitter
. If y
ou ha
v
e more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
16