Filter
Top Products
A
lign the blade and then the blade
p
late with castings on motor to
a
ttach blades to motor.
31
L
oosen 2 screws and remove 1
screw. Save screw removed.
32
Twist lower cover plate into place by
t
wisting in direction of arrow.
Replace 1 screw removed and tighten
all 3 screws securely.
33
Loosen 3 screws on light plate as
shown.
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
34
35
Place light kit over screws and twist
direction of arrow into place. Then
tighten all 3 screws securely.
36
Install glass onto light kit, install
rubber w
asher on the top side of the
screw nut to hold in place and tight-
en in direction of arrow.
38
Install 3 x 60 w
att candelabra bulbs.
Bulbs not included.
37
Install cage and finial cap and tight-
en in direction of arrow.
39
R
emo
v
e cover by snaping off from top or bot-
tom. Remove battery cover. Install 12V battery
into w
all remote. Dur
acell MN21 / Eveready A23
/ GP 23A all 12V.Attach cover of remote by plac-
ing over buttons and snap the battery cover in
place.
Place face plate o
v
er battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snaping into place.
Install w
all control unit to outlet bo
x
using machine screws pro
vided.
42
41
40
HAND HELD INSTALL
W
ALL MOUNT INST
ALL