Filter
Top Products
Tighten the 2 Set screws on the Y
ok
e
once the downrod is in place.
Insert downrod into y
ok
e on top of
the F
an Body
. Align the hole in the
Downrod with the hole in the Y
ok
e.
Insert the Pin through the Y
ok
e and
Downrod until the point appears on
the other side. Install the K
eeper Pin
Install Canop
y Co
v
er, Cage Assembly
and Y
ok
e cover onto the Downrod.
Next thread the fan leadwire from
top of fan through the downrod.
Install upper glass to top of fan.
Install tines of upper cage by inserting
into the 4 slots on the hub. Tighten
using Phillips screwdriver. Repeat 3
more times until all 4 tines are in place.
Place the Main holder over the blade
and install 3 screws and tighten
securely. Repeat this process again
for each blade
Install Blade / blade holder assembly
to fan motor using large motor
screws. Repeat this process 4 more
times until all blades are installed to
the fan.
Install 3 each Max 25 Watt cande-
labra base bulbs into the sockets on
top of the fan as shown.
Place Floating decorative holder onto
blade. The tabs should align with
the holes in the blade.
Slide the Y
ok
e Co
v
er
, and cage down on the fan
body
. The Cage should engage 4 slots in the
upper glass. Tighten the Set Screw in on the
top of the Cage. This will prev
ent an
y r
attling.
9
10
11
12
13
14
15
16
17
18
Lift mounting neck to mounting Plate and align
s
crews.
7
S
ecure mounting neck to the mounting plate
with four screws to become a complete mount-
ing bracket.
8