Filter
Top Products
C
arefully lift fan assembly onto mounting brack-
et. Rotate fan so that the notch on the ball
e
ngages the ridge in the mounting bracket. This
will allow hands-free wiring.
Install blade arms using screws and washers
provided. Tighten securely. Repeat for all 5
blades.
8
14
7
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present.
Attach blade assembly to motor using the
motor screws and washers provided. Tighten
screws securely.
15
After attaching blades install the switch housing
using the three screws previously removed.
16
Make
wire connections to power source using
w
ire nuts provided. Make
sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
10
For pullchain controls, follow diagram above.
M
ake sure that all exposed wiring is secured
i
nside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
11
House
Fan
B
lack
W
hite
G
reen
B
lack
White
Green(downrod)
G
reen(Bracket)
B
lue
For control of fan and optional light from wall
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
12
For Canadian installation and for USA fan and
l
ight kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
t
he 3” lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
i
s fully extended the leadwires are longer than
t
he cable and no stress is placed on the lead-
wires.
9
S
afety cable installation
Safety Cable
L
ag Screw
Raise the canopy up and align the two holes in
the canopy with the two holes in the hanger
bracket. Secure with two screws provided.
13
Tighten both yoke set screws to further secure
d
ownrod.
Light Switch
Fan Switch
Wall
Control
safety
cable
3” lag
s
crew
lock
washer
washer