Filter
Top Products
Hang assembled fan from the mounting bra
cket
installed to ceiling in previous step. Make
sure the
f
an is hanging straight. Rotate fan until the tab on
the Mounting bra
cket engages the slot on the
Downrod Ball. This must be done to prevent the fan
b
ody from rotating when the blades are in motion.
10
Next lift the canopy, twist into place and
tighten 2 screws securely. The canopy
should adjust for any irregularity in the
ceiling or Outlet box.
15
I
nsert downrod into yoke on top of the Fan
Body. Align the hole in the Downrod with the
hole in the Yoke. Insert the Pin through the
Yoke and Downrod until the point appears on
t
he other side. Install the keeper to pin.
Tighten the 2 set screws on the Yoke
once the downrod is in place.
7
8
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.
14
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
a
nd downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws,washers, and lock washers.
p
rovided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
w
ires.
9
S
afety cable installation
S
afety Cable
Lag Screw
safety
c
able
3” lag
s
crew
lock
washer
washer
Slide remote receiver into mounting
bracket.
13
Make
wiring connections as indicated abo
ve
.
White from fan to white from remote mark
ed
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
mark
ed L. White from house to white from
remote mark
ed AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
11
w
hite
black
S
et dip switches on the Remote Transmitter and Re
mote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
R
emote Receiver Dip switches
12
Align the blade with castings on
motor to attach blades to motor.
16
Loosen 2 screws and remove 1 screw
from motor plate and save screw.
17
Install light plate b
y twisting plate
with key hole slots into place.
Replace screw removed and tighten
the 3 screws securely.
18