Filter
Top Products
13
FIREPLACE COMPONENTS
SEE FIGURE 13 FOR ILLUSTRATION OF MODELS DESCRIBED BELOW.
53D9033. Rev 1 03/03
*
*
48" x 84" flat chase flashing with single 11" diameter hole.
16-inch x 52-inch Hearth extension for protecting floor against sparks and radiant heat.
4-inch duct connector for splicing FP4U ducts; includes one connector and two clamps.
Firestop thimble to pass chimney through ceiling. Swivels 0∞ to 15∞.
12-inch long x 8-inch diameter chimney flue section.
18-inch long x 8-inch diameter chimney flue section.
36-inch long x 8-inch diameter chimney flue section.
48-inch long x 8-inch diameter chimney flue section.
4-inch diameter outside combustion air kit. Allows air from outside to enter fireplace.
4-inch diameter x 8-feet long flexible uninsulated combustion air duct. Use with AK4 kit.
Terra cotta masonry-look chimney cap for chase top installation.
8-inch double wall Telescope pipe assembly for use with telescoping chimney caps.
Fan assembly with switch, for use with MLK36 louver kit. Installs behind MLK36's bottom
Firestop spacer, for 30-degree chimney incline through ceiling or floor.
Junction box for installation of optional FA2 fan assembly. Junction box must be installed at
time of fireplace installation if the FA2 fan assembly is to be installed.
: ASTERISK DENOTES MODEL IS NOT ILLUSTRATED BY CORRESPONDING FIGURE.
S18
S8
S12
*
*
R4884
SVTR
H1652
FP4U
AK4
403
FA2
CF8
S48
S36
JB1
SF30
louvered panel.
*
*
36" x 72" flat chase flashing with single 11" diameter hole.
Chimney support (required when chimney height exceeds 30 feet).
36-inch glass door kit with polished brass trim.
36-inch glass door kit with black trim.
required with SC round cap on 0 to 6/12 pitch roof.
0 to 6/12 variable pitch roof flashing for comtemporary installation. One 612 flashing
Round chimney cap for comtemporary installation; includes storm collar.
30-degree elbow package (package contains two 8-inch diameter elbows).
Louver kit to convert fireplace from radiant style to circulator style.
6/12 to 12/12 variable pitch roof flashing for comtemporary installation. One 1212 flashing
required with SC round cap on 6/12 to 12/12 pitch roof.
Round telescoping chimney cap; includes storm collar.
Square telescoping chimney cap (18-1/2" x 18-1/2").
R3672
MGD36B
MLK36
SCS
SE30
MGD36PB
SCL
612
SQ8
1212
SC
*
*
Hood which may be installed on fireplace in residential home to allow for the reduction of the
recommended clearance to a combustible mantel. This hood is not for use with glass doors.
H36
*
603
6-inch duct connector for splicing FP6U ducts; includes one connector and two clamps.
FP6U
6-inch diameter x 8-feet long flexible uninsulated combustion air duct. Use with AK6 kit.
AK6
6-inch diameter outside combustion air kit. Allows air from outside to enter fireplace.
SF
14-1/2" firestop spacer. One required at each ceiling or floor level.