Moen 8714 Plumbing Product User Manual


  Open as PDF
of 4
 
KITCHEN WALL MOUNT FAUCETS
Models 8713, 8714
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
MT149A
®
CAUTION:
Always turn water off before disassembling the valve. Open valve handle to
alleviate water pressure to insure that complete water shut-off has been
accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The
cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it
is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not
be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not
properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to
the premises could result.
CLIP
EAR
Measurements
ECCENTRICS
8" CENTERS
ADJUST FROM
7-1/2" TO 8-1/2"
9" SPOUT (MODEL 7400, 8713)
12" SPOUT (MODEL 8714)
7" NOMINAL
OPEN POSITION
1/2" VERTICAL
ADJUSTMENT
2-1/16"
1/2"
Complies with ASME A112.18.1M and CSA B125
next