Filter
Top Products
Troubleshooting
12
PROBLEM
Screen turns on and off
No reception at Monitor
No picture display but can
hear sound
Only Black & White picture
displayed
Batteries cannot be recharged
Camera will not link
Channels Keep Switching
Back and Forth
NORMAL SOLUTIONS
• The “VOX” mode is selected on the camera,
when there is no noise detected by the camera
it stops transmitting to save power. To turn off
select “OFF” under the “VOX” settings
switch.
• Unit has not been switched on.
• AC/DC adaptor has not been connected.
• Adjust the position of the Camera or Monitor.
• No Battery Power (check LED indicator)
• The transmitter may not be transmitting.
(either not powered on or in VOX mode)
• Wrong Channel is selected on Monitor
• Check if the LCD on/off switch.
• Low Power (Check the LED indicator)
• Check to make sure units are linked properly
• Check if transmitter has switched to night
vision mode.
• AC/DC adaptor has not been connected.
• Non-rechargeable battery has been used.
• Only special designed rechargeable batteries
can be recharged. Please contact the manufac-
turer if you have any questions.
• Unit has not been switched on.
• AC/DC adaptor has not been connected.
• Check to make sure you are making contact
with the link button.
• Check to make sure you are selecting the cor
rect channel
• Check to make sure you are not in scan mode.
To stop this feature use the channel selection
switch on the monitor and select the desired
channel