Mitsumi electronic 36 Air Conditioner User Manual


 
15
ss
ss
sCleaning the filters
Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry com-
pletely before putting them back into the unit.
Caution:
Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
Do not wash the filters in hot water (above 122 °F [50 °C]), as this
may warp them.
Make sure that the air filters are always installed. Operating the
unit without air filters can cause malfunction.
Caution:
Before you start cleaning, stop operation and turn OFF the power
supply.
Indoor units are equipped with filters to remove the dust of sucked-in
air. Clean the filters using the methods shown in the following sketches.
10. Care and Cleaning
ss
ss
sFilter removal
Caution:
In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
PEAD-A·AA
While lifting the filter knob, pull it.
A Air intake B Air outlet C Filter D Knob
Room air temperature display
setting
Automatic cooling/heating display
setting
Selecting language
English Germany Spanish Russian Italy Chinese French Japanese
8. Function Selection
9. Emergency Operation for Wireless Remote-controller (option)
ON/OFF
HEAT COOL
2
1
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not operat-
ing)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the
COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units, pushing
the
HEAT button toggles the fan on and off.
Pressing the
COOL or HEAT button selects the following settings.
Operation mode COOL HEAT
Preset temperature 24 °C/75 °F 24 °C/75 °F
Fan speed High High
B
A
D
D
C
KB79P513H01_EN.pm65 6/25/09, 5:00 PM15