Filter
Top Products
– 25 –
SELF CLEAN operation
■
CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control the
growth of mold and bacteria.
1
In order to active CLEAN operation, press the CLEAN
switch with the tip of a ballpoint pen.
Every time the CLEAN switch is pressed, the display is switched in the
order of:
No display
(CLEAN on) (CLEAN off)
NOTE
• Two hours later, the air-conditioner stops CLEAN operation automatically.
To stop the air-conditioner immediately, press the ON/OFF button.
• CLEAN operation is not operated after HEAT, FAN, OFF-TIMER, SLEEP
and ALLERGEN CLEAR operations have fi nished.
• The indoor unit fan runs for about two hours in CLEAN operation.
• The RUN light illuminates during CLEAN operation.
• Pressing the SLEEP button, ALLERGEN CLEAR button or NIGHT
SETBACK button during CLEAN operation cancels the CLEAN operation
and then the unit is set to SLEEP, ALLERGEN CLEAR or NIGHT
SETBACK operation.
• This is not a function for removing mold, germs or grime that have
already adhered to the unit.
Auto restart function
■ What is auto restart function?
• Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut, and then
automatically resumes operations after the power has been restored.
• The following settings will be canceled:
1 Timer settings
2 HIGH POWER operations
• Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs
to be switched off.
• When power failure occurs, the timer setting is canceled. Once power is resumed, set the timer again.
NOTE
Tips for effective operation
■ Please observe the following for the most economic and comfortable use of your unit.
Set a suitable room temperature.
Excessively high or low temperatures
are not good for your health and waste
of electricity.
Avoid direct sunlight and draught.
Cut out direct sunlight by drawing the
curtains or blinds when cooling. Keep
windows and doors shut, except when
ventilating.
Operate the unit only when needed.
Use the timer properly to operate the unit
only when needed.
Clean the fi lters frequently.
Clogged fi lters may block the airfl ow and
cause less effi cient operation.
Adjust the airfl ow direction properly.
Adjust the up/down and left/right airfl ow
to ensure a steady room temperature.
Keep heat source away when cooling.
Keep heat sources out of the room as
much as possible.
3 sec.
1 sec.
ON
OFF
RLD012A002G_EN.indd 25RLD012A002G_EN.indd 25 2015/02/27 14:36:432015/02/27 14:36:43