Mitsubishi Electronics PUZ-A24NHA2 Air Conditioner User Manual


 
110
OPERATING PROCEDURE PHOTOS
Photo 13
Photo 14
Compressor
(MC)
Valve bed
Separator
Separator
fixing screw
Compressor
fixing nut
Accumulator
Accumulator
Outlet
Inlet
12. Removing the compressor (MC)
(1) Remove the service panel. (See photo 1.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the conduit cover and cord cover.
(See photo 2.)
(5) Remove the back panel. (See photo 1.)
(6) Remove the electrical parts box. (See photo 5.)
(7) Remove 3 separator fixing screws (4 10) and remove
the separator.
(8) Recover refrigerant.
(9) Remove 3 compressor fixing nuts by using spanner or
adjustable wrench.
(10) Remove the welded pipe of motor for compressor inlet
and outlet.
Note: Recover refrigerant without spreading it in the air.
Accumulator leg
fixing screw
Accumulator leg
13. Removing the accumulator
(1) Remove the service panel. (See photo1.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the conduit cover and cord cover. (See photo 2.)
(5) Remove the back panel. (See photo 1.)
(6) Remove the electrical parts box. (See photo 5.)
(7) Recover refrigerant.
(8) Remove 2 welded pipes of accumulator inlet and outlet.
(9) Remove 2 accumulator leg fixing screws (4 10).
(10) Remove the accumulator together with the receiver leg.
Note: Recover refrigerant without spreading it in the air.
OCH429--4.qxp 07.11.20 9:20 AM Page 110