Filter
Top Products
6
3. Screen Confi guration
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
● Function Selection of remote controller:
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
● Set Day/Time:
Set the current day of the week or time.
● Standard Control Screens:
View and set the air conditioning system’s op-
erating status
● Timer Monitor:
View the currently set timer (weekly timer,
simple timer, or Auto Off timer)
● Timer Setup:
Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
<How to change the screen>
A : Hold down both the Mode button and the Timer On/Off button for 2
seconds.
B : Press the Timer Menu button.
C : Press the Mode (Return) button.
D : Press either of the Set Time buttons (
or ).
4. Setting the Day of the Week and Time
1. Press the or Set Time button 1
to show display 2.
2. Press the Timer On/Off (Set Day) button 9
to set the day.
* Each press advances the day shown at 3 :
Sun → Mon → ... → Fri → Sat.
3. Press the appropriate Set Time button 1
as necessary to set the time.
* As you hold the button down, the time (at 4) will increment fi rst in
one-minute intervals, then in ten-minute intervals, and then in 1-hour
intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button 4
to lock in the values.
5. Operation
˚F˚C
TIMER
MON
OFF
WEEKLY
SUNMONTUE WEDTHU FRISAT
WEEKLY
˚F˚C
˚C
TIME SUN
Function Selection of remote
controller
Set Day/Time
Standard Control Screens
Timer Monitor Timer Setup
OFF ON
˚C
˚C
TIMESUN
PAR-21MAA
ON/OFF
FILTER
CHECK
OPERATION
CLEAR
TEST
TEMP.
MENU
BACK DAY
MONITOR/SET
CLOCK
ON/OFF
Day of the Week
& Time display
TIME SUN
Day of the Week Setting
˚C
˚C
PAR-21MAA
ON/OFF
FILTER
CHECK
OPERATION
CLEAR
TEST
TEMP.
MENU
BACK DAY
MONITOR/SET
CLOCK
ON/OFF
Time Setting
Note:
The day and time will not appear if clock use has been dis-
abled at Function Selection of remote controller.
5.1. Turning ON/OFF
<To Start Operation>
■
Press the ON/OFF button 1.
• The ON lamp 1 and the display area come on.
<To Stop Operation>
■
Press the ON/OFF button 1
again.
• The ON lamp 1 and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about 3 minutes.
This is to prevent the internal components from being damaged.
2
3
4
1
9
42
1
3
2
2
3
6
1
4
5
2
5
6
2
78 6
3
3
7
5
6
7
8
7
1
1
5