Filter
Top Products
5
E Use PG bushing to keep the weight of the cable and external force from being
applied to the power supply terminal connector. Use a cable tie to secure the
cable.
F Power source wiring
G Tensile force
H Use ordinary bushing
I Transmission wiring
J Power source terminal bed
K Terminal bed for indoor transmission
L Terminal bed for remote controller
M To 1-phase power source
N Transmission line DC 30 V
O Terminal bed for outdoor transmission line (TB3)
P Transmission line to the remote controller, terminal bed for indoor unit and
BC controller
A Terminal bed
B Round terminal
C Shield wire
D The earth wire from two cables are connected together to the S terminal. (Dead-end connection)
E Insulation tape (To keep the earth wire of the shielded cable from coming in contact with the transmis-
sion terminal)
<Address board>
9.3
[Fig. 9.3.3] [Fig. 9.3.4]
[Fig. 9.5.1]
[Fig. 9.3.5]
9.5
A Terminal bed box
B Knockout hole
C RemoveA Screw holding cover (2pcs)
B Cover
[Fig. 9.3.1] [Fig. 9.3.2]
A
B
C
A
B
M2
M1
K
J
P
L
N
O
M1 M2 S
12
L
N
M
N
L
E
F
G
I
H
M2 SM1
A
B
C
E
D
A
C
FD BE
2
1
A SWA
B SWC
C SW1
D SW11
E SW12
F SW14
KB79H130H01-illust 07.4.26, 4:18 PM5