Mitsubishi Electronics MSH-GA71VB Air Conditioner User Manual


 
6
Indication Operation state
Difference between target
temperature and room
temperature
This shows that the air conditioner is operating to reach the
target temperature. Please wait until the target temperature
is obtained.
About 2°C or more
This shows that the room temperature is approaching the
target temperature.
About 2°C or less
(In case of outdoor unit MXZ series only)
Please refer to Information for multi system air conditioner.
(Page 7)
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL
COOL
DRY
AMPM
CLOCK
ßC
AMPM
WIDE VANE
LONG
HEAT
RESET
CLOCK
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL
COOL
DRY
AMPM
CLOCK
˚C
AMPM
WIDE VANE
LONG
HEAT
RESET
CLOCK
When “ (I FEEL...)” is not selected, press the
MODE
button until it is set.
Each time the button is pressed, the operation mode is changed
in sequence:
(I FEEL...) (COOL) (DRY)
(HEAT: MSH series)/
(FAN: MS series)
I FEEL... AUTO OPERATION
Description of “AUTO RESTART FUNCTION”
These units are equipped with an auto restart function. When the main power is turned on, the air conditioner will start
operation automatically in the same mode as the one set with the remote controller before the shutoff of the main power.
If the unit was set to off with the remote controller before the shutoff of the main power, it will remain stopped even after
the main power is turned on.
If the unit was in the emergency operation before the shutoff of the main power, it will start operation, when main power
comes on, in the same mode as the one set with the remote controller before the emergency operation.
If the unit is operated in “I FEEL...” mode before power failure, the operation is not stored in the memory. In “I FEEL...”
mode, the operation is decided by the initial room temperature at (re) start.
To start operation:
Press the
ON/OFF
button.
When the “ (I FEEL...)” mode is selected, the air conditioner is automatically
controlled at the optimum temperature.
To stop operation:
Press the
ON/OFF
button.
If you feel slightly warm:
Press the
TOO
WARM
button to lower the temperature.
One press lowers the temperature by about 1°C.
If you feel slightly cool:
Press the
TOO
COOL
button to raise the temperature.
One press raises the temperature by about 1°C.
With the “ (I FEEL...)” auto operation mode, the optimum room condition can be set automatically
with a one-touch operation.
NOTE:
COOL: When the room temperature is 2°C higher than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until
the room temperature drops to within 2°C of the set temperature and then change the set temperature.
HEAT: When the room temperature is 2°C lower than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until
the room temperature rises to within 2°C of the set temperature and then change the set temperature.
Details of operation
According to the room temperature when the operation starts, the operation mode is automatically set to COOL, DRY
or HEAT. However, when operation is started again within 2 hours after it is stopped, the same operation mode before
the operation is stopped is selected. The operation mode selected first is not changed even if the room temperature
changes. If the operation mode does not match the room condition, select the appropriate operation mode by pressing
the
MODE
button.
Description of “I FEEL...” mode
Operation Indicator
The operation indicator at the right side of the indoor unit indicates the operation state.
Lighted
Blinking
Not lighted
Operation indicator lamp
COOL & HEAT type (MSH series) COOL ONLY type (MS series)
Room temperature
when started
Operation mode
Target temperature
(initial state)
Operation mode
Target temperature
(initial state)
About 25°C or higher COOL About 24°C COOL About 24°C
About 25°C - 23°C DRY DRY
About 23°C or lower HEAT About 26°C DRY
Details of auto operation
Details of display on the indoor unit
4/21/06 2:49:38 PM