Mitsubishi Electronics MCF-SD13VD Air Conditioner User Manual


 
En-3
• OPERATING INSTRUCTIONS •
Press CLOCK gently using a thin stick.
T
E
S
E
R
K
C
O
L
C
T
E
S
E
R
K
CO
L
C
2.
Press the and buttons
to set the time
Each time is pressed, the
set time
increases by 1
hour, and each time is pressed,
the set time increases by 1
minute.
L
E
E
F
I
L
O
O
C
Y
R
D
N
A
F
P
M
A
M
P
M
A
M
Temperature buttons
Page 4
Off-timer button Page 6
On-timer button Page 6
TIME set buttons Pages 3, 5
HR. button
MIN. button
CLOCK button Page 3
RESET button Page 3
Lid
Slide down to open
• Make sure the polarity of the batteries is correct.
Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin stick.
If the RESET button is not pressed, the remote controller may not operate correctly.
Display section
Operation indicator
lamp
Remote control
receiving section
Emergency operation switch
Page 4
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep (s) is (are) heard
from the indoor unit when
the signal is received.
Operation display
section
ON/OFF
(operate/stop)
button
Operation
select button
Page 4
FAN speed
control button
Page 5
VANE
control button
Page 5
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
Use the remote controller provided with the unit only.
Do not use other remote controllers.
Vertical vane
Air inlet
Front panel
Outdoor unit
NAME OF EACH PART
PREPARATION BEFORE OPERATION
1.
Remove the front lid
2.
Insert AAA
alkaline batteries
3.
Install the front lid
1.
Press CLOCK
3.
Press CLOCK again
Indoor unit Remote controller
Appearance of the outdoor unit may differ from some models.
4.
Press RESET
Installing the remote controller batteries Setting current time
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Air cleaning fi lter (Option)
Deodorizing fi lter (Option)
Air fi lter
Horizontal vane
When installed on the ceiling